SFUMIA / Documentation
Guide
Inspect media in the Viewer
Check an image or video, compare results and read useful measurements.
In this guide
Open the intended result
You can detach the Viewer onto another screen. Files stay in your project storage.
- Open the Viewer from SFUMIA’s modules.
- Choose a project output you can access.
- Check its name, version, dimensions and frame rate before reviewing it.
Frame the image and inspect detail
The wheel zooms around the pointer. Use the middle button or Hand tool to pan, and fit the image to see it all. Native-pixel viewing helps inspect fine detail.
A large image may load visible detail progressively. A reduced preview does not replace the original file or guarantee real-time playback of a whole sequence.
Read passes and colour
For a compatible EXR, select an available pass and its interpretation: Auto, Colour or Raw data. The picker reads that pass’s native values. Exposure, gamma and colour views affect presentation, without correcting the source media.
The Viewer decodes uncompressed, ZIP, ZIPS and PIZ EXR files directly. Other compressions are shown through an 8-bit PNG compatibility preview prepared by the service, without changing the file; measure native values on a directly decoded file. Exposure ranges from −5 to +5 EV and is not shared with the other modules.
Precision, previews and the source file
Floating-point processing can preserve negative values and values above 1. File bit depth, processing precision and the screen’s HDR capability are different things.
Displaying an 8-bit file with 32-bit processing does not recover missing detail. For a measurement, check the pass and native values rather than only the preview.
Compare and measure
Measurements complement visual inspection. A linear or HDR scale does not itself define delivery settings.
- Choose media A and B, then an available comparison mode.
- Check each side’s pass, colour view and, for video, the frame being inspected.
- Open the histogram, waveform, RGB parade or vectorscope as needed.
- Choose the measurement area: whole image, visible area or a defined region.
Play video and listen to audio
Use play, pause, frame stepping, in/out points and looping. With the Viewer active, J, K and L control transport. The cache bar shows loaded frames; missing frames remain identified.
For compatible audio, adjust listening controls and use the waveform to navigate. Audio mixing and export take place in Montage.
On-demand audio measurements
Channel analysis and LUFS/true-peak analysis inspect authorised media without changing the file or listening volume. They require compatible audio components in the installation.
A mono waveform does not show every channel difference. Silence, very short audio or interrupted analysis may not provide a usable measurement.
What the analyses measure
« Mesurer les canaux » calculates, for each channel of the first audio stream, the sample peak, the RMS level in dBFS, the DC offset and the number of full-scale samples; up to 32 channels, 384 kHz and 24 hours. Sample peaks are not true peaks and the RMS is not weighted.
« Mesurer LUFS / crête réelle » gives the integrated loudness, the loudness range (LRA) and the true peak, to two decimal places, up to eight channels (7.1) and 192 kHz, without dual-mono compensation. Below 400 ms, integrated loudness is not measured; LRA needs at least 3 seconds.
Understand the HDR option
HDR presentation is experimental and depends on your screen, Windows HDR mode and browser. In this version it applies to images using the sRGB view; an incompatible colour view or display table prevents that output.
Keep going
Available features depend on your version and installation.