SFUMIADocumentation
Private test version

Guide

Prepare and share a prompt

Write an instruction, connect it to compatible nodes and check the text before running a calculation.

Updated
In this guide

Add the text

  1. In the intended project, add « Texte/Prompt » from the Text category.
  2. Reserve the node before editing its content. Also reserve any other nodes you will change.

Write a clear instruction

Enter the text in the node. Describe the subject, framing and details that matter to the result. Read the instruction before adding settings.

Empty text or text containing only spaces supplies no prompt.

An example description

A white ceramic cup on a wooden table. Close view from a three-quarter angle. Soft light from the left, plain background.

Adapt this description to your intention. The node passes on your text; it does not automatically translate or improve it.

Keep independent variants

Use separate Texte/Prompt nodes when instructions need to change independently. After changing a connection, read the destination field again: an earlier text may remain there.

Text generated by another node may appear read-only in the inspector. This differs from shared manual text.

Read the project’s texts

This list may not cover every node type. It does not replace the graph, settings or generation results.

  1. In the project properties, find the prompts section and choose « Prévisualiser ».
  2. Read the recognized texts, grouped by shot and node, then close the preview.

Check before running

  1. Check that changes are saved and address any saving or permission error.
  2. Read the prompt in the destination node, then check its model, settings and execution mode.
  3. Explicitly start the intended calculation and inspect its new result. Create a version or publish only when you choose to.

Available features depend on your version and installation.

Search the guides

Type a word or choose a guide.

Language

العربيةবাংলাEnglishEspañolFrançaisहिन्दीBahasa IndonesiaPortuguêsاردو简体中文

Change theme